Appendix Insulation
The construction of plaster of light 'Radeks' must comply with the requirements of zharnym opposite and one of the variants of Appendix A. Marks polimermineralnyh compositions and mineral compositions polimermineralnyh should be taken in accordance with the the constructive solutions. The system is attached to the outer surface of the walls, made of various materials (except wood). Mounting plates for insulation prepared surface of the walls should be done with glue, and anchoring devices, which transmit the load on system design, insulation on the wall of the building. Load-bearing elements of the system is insulated and PLI-you anchors. Thermal insulation properties of ensured insulating layer, which should be carried out plates of mineral wool or polystyrene foam boards. Architectural requirements are provided to the front Decorative and protective coating.
Color color of decorative and protective layer preferably perform compositions from light colors, especially for painting the facades on the east and south sides. The compositions of dark tones may be used for shaded areas of the facade (north side, balconies, etc.). Should not be allowed on a facade of contrasting color combinations too. To protect the insulation board from mechanical damage, to ensure the safety and crack decorative protective layer on the surface of the insulation boards should arrange reinforced layer. Reinforced layer of glue should be done, armiruemogo alkali-resistant glass losetkoy.
Thickness reinforced, decorative and protective layers depends on the option chosen design solution insulation system. Depending on the possibility of mechanical impact, thermal insulation, reinforcement can performed by one or two layers of fiberglass. Lots of walls, where possible mechanical impacts during the operation (the lower part of the facade – at least 2.5 m from ground level mark, sites operated by loggias on the walls (Balconies), downhill to the basement, etc.) should be reinforced with two layers of fiberglass. Place additional reinforcement should be specified in the project documentation. When neuteplyaemom pedestal bottom insulation layer system insulation should be placed below the insulation, laid on the ceiling of the ground floor, no less than 250 mm.
Comments