Construction Of A Wooden Shed
Posted By on February 10, 2017
Wooden shed – a very significant building near her house. In a wooden shed can store a different workflow tools, building materials for construction and finishing, the wood for the stove, soil amendment, in general, different inventory. When choosing a place (site) for the erection of shed, you must follow these rules: What would shed no conspicuous guests it is necessary to build deeper on the site. Sarah did not need to build on the boundary of the site should withdraw from it 1-1,5 m Should not build a wooden shed in the lowlands area, since snow melt, heavy rains there will accumulate water. It will heat a little wooden structure.
Foundation for the barn selected depending on the soil if the soil clay, then you need to make a sandy base at a depth of 60cm. If the soil is sandy, it is sufficient to remove all vegetation from the surface and flatten it. It should be noted that the tape and reinforced concrete foundations in the construction of a wooden shed to lay senseless. Foundation can be a bar, using bricks, asbestos pipes and concrete. Bollards should be placed in the corners of buildings, facade side and rear. Built on pier foundation is laid waterproofing, roofing felt fit. His laid in two layers for the erection of bollards. Next is tying of timber with a cross section 100×150 mm.
Bars construction fastened with nails in 'poldereva'. When mating the boards to keep a flat plane, will help building level, the usual long flat rail. After the rail ready to fit it lags in Later they plank wood floor. Logs can be made from a wooden beam cross section 40×80 mm, they should be laid on the 'edge'. By the end of construction wood nastelenny floor fitted and hammered nails. Next, prepare four frames of which will be sealed with a wooden frame barn. Need to make a frame on front, rear and side walls. First, the side frames are made, as from them will depend on the width of the structure. The frame consists of the following elements stand, raskosina, truss girder and sill trim. For the side walls can take the board with a width of 40mm, and for front and rear walls better to take a wider, for example 80mm. No design elements should not be above the top truss girder. Installation of wooden frames prepared as follows: the first set vertical side frame and fixed props. In subsequent to it puts the frame front and rear walls and secured by the same metal nails. In the finale of plumb (lace with sinker) are installed rafter beams, the latter secured the second lateral wooden frame. At the end of the construction is done for the roof purlins, and it is placed finish. Coating for roofs can serve as a slate, profile, and other building roofing materials. Here are some of the scheme carried out the construction of the barn with their hands in the end should be a good wooden shed, which will serve many of the summer.
Comments